Loading... Please wait...Coleman's 6 Watt 12V Solar Battery Charger has trickle charging power for large 12V deep-cycle batteries, keeping the batteries full during periods of storage. No need to remove from your car. Just use the cigerette lighter adapter to transfer power to your battery or hook directly to the battery with the included battery clamps. No more dead batteries worries with this automotive solar battery charger. Quickly install the Sunforce 12 volt battery charger and enjoy eco freindly free charging from the sun. Also works great for a solar battery charger for boats.
The Coleman 12V Solar Battery Charger will not over charge your battery. This weatherproof solar saver helps extend the battery-life of your cars, RVs and mid-size boats. It is even efficient under low-light and extreme weather conditions. It can also be used as a charger for portable electronics, fence chargers, gate openers, and deer feeders.
Maximum power output 6 Watts and 400Mah
Dimensions: (L x W x H) 18" x 1.5" x 14.5" / 45 x 3 x 36cm
Weight: 4.6 lbs(2.1Kg)
Can I use panel outdoors?
Yes, this panel has been weatherproofed. The weatherproofing includes UV protection and weather effects of -35º F to 175 º F
Will my panel drain a battery at night?
No, this panel includes a blocking diode to prevent battery drain and reverse current.
What type of battery can a trickle charge?
Any 12 volt battery can be trickle charged with this solar panel.
How long will it take to charge a battery?
Under ideal conditions, this panel will generate up to 400 mAmps of current, supplying a steady trickle charge to any 12 volt battery.
Do I need a charge controller?
A charge controller is not required for a 6 Watt solar panel. A 6 Watt panel will not overcharge your 12 Volt battery. A charge controller is recommended for panels greater than 15 Watts.
Can I run appliances off this panel?
Yes, however, the current will vary depending on the sunlight. Charging a battery is therefore the recommended installation and running protocol.
Can I mount this panel directly on a surface?
Yes, this panel can be mounted with the included stainless steel screws. To increase the heat dissipation, a heat resistant spacer should be used between panel and surface for optimized use.
How far can I extend the wire?
Current length should accommodate 95% of installations; however, wires can be extended up to a maximum of 30 feet with 16 gauge wires. Stripping wires to extend should be done carefully, connecting positive to positive and negative to negative appropriately